Fagor CNC 8060 - Page 123

Installation manual
CNC 8060
CNC 8065
MACHINE PARAMETERS.
2.
(REF: 1402)
·123·
Machine parameters for the axes and spindles.
MANFEEDP
Maximum % of jog feedrate in G201.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 0 to 100.
Default value: 20.
Associated variable: (V.)[ch].MPA.MANFEEDP.xn
Parameter included in the JOG table.
See axis machine parameters IPOFEEDP.
IPOFEEDP
Maximum % of execution feedrate in G201.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 0 to 100.
Default value: 80.
Associated variable: (V.)[ch].MPA.IPOFEEDP.xn
Parameter included in the JOG table.
When using function G201, Manual mode laid over the Automatic mode, both parameters
indicate the maximum feedrate to be used in each mode. The sum of both parameters should
not exceed 100 in order so as not to exceed the dynamic limits of the machine under certain
conditions.
When activating function G201, the feedrate assumes instantaneously the value set by
IPOFEEDP.
MANACCP
Maximum % of jog acceleration in G201.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 0 to 100.
Default value: 20.
Associated variable: (V.)[ch].MPA.MANACCP.xn
Parameter included in the JOG table.
See axis machine parameters IPOACCP.
IPOACCP
Maximum % of execution acceleration in G201.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 0 to 100.
Default value: 80.
Associated variable: (V.)[ch].MPA.IPOACCP.xn
Parameter included in the JOG table.
When using function G201, Manual mode laid over the Automatic mode, both parameters
indicate the maximum acceleration to be used in each mode. The sum of both parameters
should not exceed 100 in order so as not to exceed the dynamic limits of the machine under
certain conditions.