Fagor CNC 8060 - Page 130

·130·
Installation manual
CNC 8060
CNC 8065
2.
MACHINE PARAMETERS.
(REF: 1402)
Machine parameters for the axes and spindles.
DEFAULTSET
Set of default parameters on power-up.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 0 to 4.
Default value: 1.
Associated variable: (V.)[ch].MPA.DEFAULTSET.xn
This parameter indicates the parameter set assumed by the CNC on power-up, after
executing an M02 or M30 or after a reset. When defined with a "0" value, the parameter set
is always maintained.
To select a parameter set on the axis or spindle via part-program, use function G112. To
select a parameter set on a spindle and make a gear change, use functions M41 through
M44.
SET n
Work sets.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
It shows the machine parameter table of the set.