Fagor CNC 8060 - Page 138

·138·
Installation manual
CNC 8060
CNC 8065
2.
MACHINE PARAMETERS.
(REF: 1402)
Machine parameters for the axes. Work sets.
When trying to exceed the maximum feedrate via part-program, via PLC or from the operator
panel, the CNC limits the feedrate to the maximum value set in MAXFEED without showing
any error message or warning.
If the machining feedrate is not limited, the CNC assumes for all the movements the one set
in machine parameter G00FEED as the maximum feedrate.
MAXVOLT
Velocity command to reach G00FEED.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drives and velocity-Sercos drives.
Possible values: from0 to 10000.0000 mV.
Default value: 9500 mV (9.5 V).
Associated variable: (V.)[ch].MPA.MAXVOLT[set].xn
This is the velocity command the CNC must output so the axis can reach its maximum rapid
traverse feedrate G00FEED.
MAXFREQ
Frequency required to reach G00FEED.
Parameter valid for spindles.
Parameter valid for a Mechatrolink inverter.
Possible values: From 0,0010.0000 to 10000.0000 Hz.
Default value: 50 Hz.
Associated variable: (V.)[ch].MPA.MAXFREQ[set].xn
When the drive is an inverter, this parameter indicates the frequency to be provided by the
CNC for the spindle to reach the speed set in parameter G00FEED.
MAXRPM
Maximum motor rpm.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for a Mechatrolink speed and inverter.
Possible values: From 0 to 100000 rpm.
Default value: 3000 rpm.
Associated variable: (V.)[ch].MPA.MAXRPM[set].xn
Maximum motor rpm.
RAPID TRAVERSE FOR THE AUTOMATIC MODE.
FRAPIDEN
Rapid traverse of the axis for movements in automatic mode.
Possible values: From 0 to 500000.0000 mm/min / from 0 to 19685.03937 inch/min.
Default value: 0.
Associated variable: (V.)[ch].MPA.FRAPIDEN[set].xn
Maximum feedrate of the axis for the program being executed, when the rapid traverse for
the automatic mode is active (parameter RAPIDEN). If the parameter is set with a "0" value,
the feedrate is not limited. The value of this parameter must always be lower than that of axis
parameter G00FEED.
Variable. Machine parameters. Feedrate.
(V.)PLC.G00FEED G00FEED (axis) MAXFEED (axis) G00 G01, G02, ···
0 10000 0 10000 10000
0 10000 6000 10000 6000
4000 10000 6000 4000 4000
7000 10000 6000 7000 6000
12000 10000 6000 10000 6000