Fagor CNC 8060 - Page 143

Installation manual
CNC 8060
CNC 8065
MACHINE PARAMETERS.
2.
(REF: 1402)
·143·
Machine parameters for the axes. Work sets.
LFEED
Acceleration changing speed.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 0 to 200000.0000 mm/min or degrees/min / from 0 to 7873.992 inch/min / from
0 to 100000.0000 rpm.
Default value: 1000.0000 mm/min, degrees/min or rpm / 39.37008 inch/min.
Associated variable: (V.)[ch].MPA.LFEED[set].xn
While accelerating, when reaching the feedrate defined in this parameter, it changes the
acceleration from LACC1 to LACC2. While decelerating, when reaching the feedrate defined
in this parameter, it changes the acceleration from LACC2 to LACC1.
TRAPEZOIDAL AND SQUARE SINE ACCELERATION.
ACCEL
Acceleration.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 0.001 to 100000.0000 mm/s² or degrees/s² / from 0.0003937 to 3937.00787
inch/s².
Default value: 1000.0000 mm/s² or degrees/s² / 39.37008 inch/s².
Associated variable: (V.)[ch].MPA.ACCEL[set].xn
See machine parameter DECEL.
DECEL
Deceleration.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 0.001 to 100000.0000 mm/s² or degrees/s² / from 0.0003937 to 3937.00787
inch/s².
1 Acceleration according to parameter LACC1 until reaching the feedrate indicated in
LFEED.
2 Acceleration according to parameter LACC2 until reaching the programmed feedrate.
3 Movement at programmed feedrate (without acceleration).
4 Deceleration according to parameter LACC2 until reaching the feedrate indicated in
LFEED.
5 Deceleration according to parameter LACC1.
LACC1
LACC2
- LACC2
- LACC1
t
a
t
F
LFEED
1
2
3
5
4