Fagor CNC 8060 - Page 149

Installation manual
CNC 8060
CNC 8065
MACHINE PARAMETERS.
2.
(REF: 1402)
·149·
Machine parameters for the axes. Work sets.
CORNERACC
Maximum acceleration permitted at the corners.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 0 to 100000.0000 mm/s² or degrees/s² / from 0 to 3937.00787 inch/s².
Default value: 0.
Associated variable: (V.)[ch].MPA.CORNERACC[set].xn
This parameter sets the maximum acceleration allowed for the axis during block transition.
If this parameter is set with a ·0· value, the maximum acceleration of the axis is respected.
CURVACC
Maximum contouring acceleration permitted.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 0 to 100000.0000 mm/s² or degrees/s² / from 0 to 3937.00787 inch/s².
Default value: 0.
Associated variable: (V.)[ch].MPA.CURVAACC[set].xn
If this parameter is set with a ·0· value, the maximum acceleration of the axis is respected.
CORNERJERK
Maximum Jerk permitted at the corners.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 0 a 1000000000.0000 mm/s³ or degrees/s³ / from 0 to 39370078.74016 inch/s³.
Default value: 0.
Associated variable: (V.)[ch].MPA.CORNERJERK[set].xn
If this parameter is set with a ·0· value, the maximum jerk of the axis is respected.
CURVJERK
Maximum contouring Jerk permitted.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 0 a 1000000000.0000 mm/s³ or degrees/s³ / from 0 to 39370078.74016 inch/s³.
Default value: 0.
Associated variable: (V.)[ch].MPA.CURVJERK[set].xn
If this parameter is set with a ·0· value, the maximum jerk of the axis is respected.
FASTACC
Maximum acceleration permitted (FAST mode).
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 0 to 100000.0000 mm/s² or degrees/s² / from 0 to 3937.00787 inch/s².
Default value: 0.
Associated variable: (V.)[ch].MPA.FASTACC[set].xn
If this parameter is set with a ·0· value, the maximum acceleration of the axis is respected.
MAXERROR
Position error.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 0 to 9999.99999 mm or degrees / from 0 to 3937.00787 inch.
Default value: 0.1000 mm / 0.00394 inch.
Associated variable: (V.)[ch].MPA.MAXERROR[set].xn
Maximum axis position error in HSC when working outside the plane/trihedron.