Fagor CNC 8060 - Page 188

·188·
Installation manual
CNC 8060
CNC 8065
2.
MACHINE PARAMETERS.
(REF: 1402)
Machine parameters for kinetics.
TDATA16
Rotate the part coordinate system when rotating the table.
Possible values: 0 / 1.
Default value: 0.
Having the RTCP mode active, this parameter determines whether the part coordinate
system is fixed on the part and rotates with it or it stays parallel to the machine coordinate
system.
TDATA16 Meaning.
0 When changing the part orientation, the position occupied by the tool tip on the
part does not change. The coordinate system is fixed on the part and rotates with
it.
1 When changing the part orientation, the position occupied by the point set as part
zero does not change. The coordinate system stays parallel to the machine
coordinate system.
X'
Z'
#RTCP ON
B-30
B
TDATA16 = 0
X
'
Z
'
TDATA16 = 1
X'
Z'