Installation manual
CNC 8060
CNC 8065
MACHINE PARAMETERS.
2.
(REF: 1402)
·217·
OEM machine parameters.
INCHES
The parameter is affected by the change of units.
Possible values: Yes / No.
Default value: Yes.
This field indicates whether the value of the parameter is affected by the change of units,
mm or inches. For example, when the parameter represents a coordinate.
COMMENT
OEM parameter description.
This field offers the possibility to associate a short description with the parameter. This field
is for information only; it is not used by the CNC.
The comments are saved in the file MTBComments.txt and it is possible to have one file per
language. These files are saved in the folder C:\CNC8070 \MTB \data \Lang".
CAM EDITOR.
The cam editor is an graphic assistance element for designing cams. The user must make
sure that the design is coherent with the required specifications.
CAMTABLE
Table of electronic cams.
This table shows the parameters to define the electronic cams. The table has the following
machine parameters.
SIZE
Number of electronic cams.
Possible values: From 0 to 16.
Default value: 0.
Parameter included in the CAMTABLE table.
This parameter sets the number of electronic cams of the system.
DATA
List of electronic cams.
This parameter shows the list of available cams.
CAM n
Electronic-cam editor.
Cam editor with friendly assistance to analyze the behavior of the cam projected through
graphically assisted data entry for speed, acceleration and jerk.
CAMTABLE
SIZE Number of electronic cams.
DATA List of cams.
CAM n Access the cam editor.
This function has a specific manual.
Refer to the documentation included in the CD-ROM that comes with the product for further information
on the requirements and operation of the electronic cam.
To Next Page
Loading...
