Installation manual
CNC 8060
CNC 8065
INTRODUCTION TO THE PLC.
3.
(REF: 1402)
·237·
Operation of a timer.
Operation of the TRS input in this mode.
If an up-flank occurs at the TRS input while timing or after it, the PLC resets the timer setting
its status output low (T=0) and resetting its timing (t=0).
Since the timer is reset, its trigger input must be activated again to turn it back on.
Operation of the TEN input in this mode.
If once the timer has been activated, TEN = 0, the PLC interrupts the timing and TEN must
be set to "1" to resume timing.
To Next Page
Loading...
