·246·
Installation manual
CNC 8060
CNC 8065
4.
PLC PROGRAMMING.
(REF: 1402)
Directing instructions.
NOMONIT
No monitoring.
When programming this directing instruction, it does not generate information necessary to
monitor the PLC program. In other words, the program is not monitored.
It must always be programmed at the beginning of the program, before the DEF instruction
and the modules: CY1, PRG and PEt.
This instruction should only be used when the PLC program execution time is very critical.
Define it after debugging the PLC program.
Programming example.
;No monitoring
NOMONIT
;External subroutine
EXTERN TEMPERATURE
;Symbol definition
DEF COOL I12
DEF /FAN I23
;CY1 module
CY1
···
END
;PRG module
PRG
···
IMA I3 AND REA M4 = 02
···
L_GEAR
···
END
;PEt module
PE 100
···
END
;Subroutine
SUB A22
···
END
To Next Page
Loading...
