Fagor CNC 8060 - Page 258

·258·
Installation manual
CNC 8060
CNC 8065
4.
PLC PROGRAMMING.
(REF: 1402)
Action instructions.
The origin and destination registers must always be defined, even when they are both the
same. The number of repetitions indicates the consecutive number of times the register will
be rotated.
RR1 R100 1 R200
It makes one type-1 right-hand rotation of R100 leaving the result in R200.
RL2 R102 4 R101
It makes four type-2 left-hand rotation of R102 leaving the result in R101.