Fagor CNC 8060 - Page 290

·290·
Installation manual
CNC 8060
CNC 8065
6.
LOGIC CNC INPUTS AND OUTPUTS.
(REF: 1402)
General consulting signals.
SBOUT
There is a mark for each channel. The mnemonics for each channel are the following.
SBOUTC1 (can also be programmed as SBOUT)
SBOUTC2 SBOUTC3 SBOUTC4
The CNC sets this mark high (=1) when the Single Block mode is selected.
• If the –single block– mode is selected while in automatic mode, the AUTOMAT and
SBOUT marks are activated.
• If the –single block– mode is selected while in JOG mode, the MANUAL and SBOUT
marks.
INCYCLE
There is a mark for each channel. The mnemonics for each channel are the following.
INCYCLEC1 (can also be programmed as INCYCLE)
INCYCLEC2 INCYCLEC3 INCYCLEC4
The CNC sets this mark high (=1) when executing a block or moving an axis.
• In execution. It is set high (=1) at the beginning of the execution and it stays high until
the end, until the [STOP] key is pressed or until the "_STOP" mark is set low (=0).
• In MDI or Single Block execution, it is set low (=0) at the end of the block.
• In JOG mode, it stays high (=1) while any of the JOG keys is pressed.
RAPID
There is a mark for each channel. The mnemonics for each channel are the following.
RAPIDC1 (can also be programmed as RAPID)
RAPIDC2 RAPIDC3 RAPIDC4
The CNC channel sets this mark high (=1) when executing a rapid traverse movement (G0).
ZERO
There is a mark for each channel. The mnemonics for each channel are the following.
ZEROC1 (can also be programmed as ZERO)
ZEROC2 ZEROC3 ZEROC4
The CNC sets this mark high (=1) when searching home (G74).
PROBE
There is a mark for each channel. The mnemonics for each channel are the following.
PROBEC1 (can also be programmed as PROBE)
PROBEC2 PROBEC3 PROBEC4
The CNC channel sets this mark high (=1) when executing a probing movement (G100).
THREAD
There is a mark for each channel. The mnemonics for each channel are the following.
THREADC1 (can also be programmed as THREAD)
THREADC2 THREADC3 THREADC4
The CNC sets this mark high (=1) when executing an electronic threading block (G33).