Installation manual
CNC 8060
CNC 8065
LOGIC CNC INPUTS AND OUTPUTS.
6.
(REF: 1402)
·305·
Consulting signals for the spindle.
SYNCPOSI
There is a mark for each spindle. The mnemonics for each spindle are the following:
SYNCPOSI1 SYNCPOSI2 SYNCPOSI3 SYNCPOSI4
This mark is activated at the slave spindle when it is synchronized in position.
This mark is set to (=0) when exceeding the maximum position error allowed, whose default
value is set by machine parameter DSYNCPOSW.
GEAROK
There is a mark for each spindle. The mnemonics for each channel are the following.
GEAROK1 (can also be programmed as GEAROK)
GEAROK2 GEAROK3 GEAROK4
The spindle activates this mark when the parameter set selected at the CNC and at the PLC
are the same. In order for both parameter sets to coincide, funciton M41 must be active at
the CNC and the GEAR1 mark at the PLC, M42 with GEAR2 and so on.
If both parameter sets do not coincide, the CNC executes no action. Include this mark in the
PLC maneuver to define the actions to carry out when both parameter sets do not coincide,
such as stop the spindle or interrupt the execution of the part-program.
To Next Page
Loading...
