Installation manual
CNC 8060
CNC 8065
LOGIC CNC INPUTS AND OUTPUTS.
6.
(REF: 1402)
·307·
Consultation signals of the independent interpolator.
LATCH1DONE(axis)
LATCH2DONE(axis)
It is applied when latching the coordinate of an axis. There is a mark for each probe. Probe
1 will be the one assigned to parameter PRBDI1 and probe 2 will be the one assigned to
parameter PRBDI2.
The independent interpolator actives this mark when the latch event on the axis with the
indicated probe occurs; it deactivates it when activating a new latching process on the axis
with the same probe.
To Next Page
Loading...
