Installation manual
CNC 8060
CNC 8065
LOGIC CNC INPUTS AND OUTPUTS.
6.
(REF: 1402)
·309·
Tool manager consulting signals.
TMINEM
There is a register for each magazine. The mnemonics for each magazine are the following.
TMINEMZ1 (can also be programmed as TMINEM)
TMINEMZ2 TMINEMZ3 TMINEMZ4
The CNC sets this mark high (=1) to inform the PLC that an emergency has occurred at the
tool manager.
MZID
There is a register for each channel. The mnemonics for each channel are the following.
MZIDC1 MZIDC2 MZIDC3 MZIDC4
This register indicates which magazine contains the tool requested by the channel.
When two magazines are involved in a tool change, the lower portion of this register indicates
the destination magazine for the tool and the higher portion the source magazine for the tool.
To Next Page
Loading...
