Installation manual
CNC 8060
CNC 8065
LOGIC CNC INPUTS AND OUTPUTS.
6.
(REF: 1402)
·311·
Keystroke consulting signals.
Registers KEYBD1 / KEYBD1_1 to KEYBD1_8. Jog keys.
Registers KEYBD2 / KEYBD2_1 to KEYBD2_8.
When the operator panel has a spindle speed override switch, the keys associated with the
speed override (bits 0 and 4) no longer have this functionality and may be configured from
the PLC.
Bit Jog Panel LCD-10K
16 Jog key 1 Jog key 1
17 Jog key 2 Jog key 2
18 Jog key 3 Jog key 3
19 Jog key 4 Jog key 4
20 Jog key 5 Jog key 5
21 Jog key 6 Jog key 6
22 Jog key 7 Jog key 7
23 Jog key 8 Jog key 8
24 Jog key 9 Jog key 9
25 Jog key 10 - - -
26 Jog key 11 - - -
27 Jog key 12 - - -
28 Jog key 13 - - -
29 Jog key 14 - - -
30 Jog key 15 - - -
31 - - - - - - -
Bit Key Bit Selector
0 Spindle override + 10 Generic key 3
1 Spindle clockwise 11 ZERO
2 Spindle positioning 12 - - -
3 Spindle stop 13 Single block
4 Spindle override - 14 CNC OFF
5 Spindle counterclockwise 15 RESET
6 START 16 - 20 Feed override
7 STOP 21 - 23 - - -
8 Generic key 1 24 - 27 Mode selector
9 Generic key 2 28 -31 ZERO
1
4
2
5
3
6
789
10 11 12
13 14 15
To Next Page
Loading...
