Installation manual
CNC 8060
CNC 8065
TOOL AND MAGAZINE MANAGEMENT.
7.
(REF: 1402)
·391·
Synchronous magazine with changer arm and 1 claw
$CASE 7
Leave the spindle tool on the ground and take another one from the magazine.
LL SUB_SPD_GMCHG
Move the spindle to the manual tool change point.
LL SUB_SPD_TO_GR
Remove the tool from the spindle.
LL SUB_SPD_AUTCHG
Move the spindle to the automatic tool change point
LL SUB_MZ_TO_CH1
Take the tool from the magazine with holder 1.
LL SUB_CH1_TO_SPD
Take the tool of holder 1 to the spindle.
$BREAK
$CASE 8
Leave the spindle tool on the ground and take another one from ground.
LL SUB_SPD_GMCHG
Move the spindle to the manual tool change point.
LL SUB_SPD_TO_GR
Remove the tool from the spindle.
LL SUB_GR_TO_SPD
Insert the ground tool in the spindle.
$BREAK
$CASE 9
Take a ground tool to the magazine going through the spindle.
LL SUB_SPD_GMCHG
Move the spindle to the manual tool change point.
LL SUB_GR_TO_SPD
Insert the ground tool in the spindle.
LL SUB_SPD_AUTCHG
Move the spindle to the automatic tool change point
LL SUB_SPD_TO_CH1
Take the spindle tool with holder 1.
LL SUB_CH1_TO_MZ
Leave the tool of holder 1 in the magazine.
$BREAK
$CASE 10
Take a tool from the magazine and leave on the ground going through the spindle.
LL SUB_SPD_AUTCHG
Move the spindle to the automatic tool change point
LL SUB_MZ_TO_CH1
Take the tool from the magazine with holder 1.
LL SUB_CH1_TO_SPD
Take the tool of holder 1 to the spindle.
LL SUB_SPD_GMCHG
Move the spindle to the manual tool change point.
LL SUB_SPD_TO_GR
Remove the tool from the spindle.
$BREAK
To Next Page
Loading...
