·42·
Installation manual
CNC 8060
CNC 8065
2.
MACHINE PARAMETERS.
(REF: 1402)
Selection of parameter values.
The icons appearing next to the parameter value permit accessing the list of pre-established
values, a data table, a set of parameters or to refer to a file. For those parameters that do
not have an icon next to them, a value must be edited within the indicated range.
Default value of the parameters at a simulator.
When the CNC is installed as a simulator at a PC, the default value of certain machine
parameters may be different from those mentioned here. The changes basically have to do
with the maximum axis feedrates, accelerations and jerk. The probe data has also been
changed in order to have, in jog mode, the part centering and tool calibration cycles.
Icon. Meaning.
The parameter has a list of options.
To access a data table.
To access a group of parameters.
The parameter refers to a file.
To Next Page
Loading...
