Fagor CNC 8060 - Page 438

·438·
Installation manual
CNC 8060
CNC 8065
9.
CONCEPTS.
(REF: 1402)
Configure the name and number of axes and spindles.
MILLING MACHINE WITH 1 CHANNEL, 5 AXES (2 FREE) AND
1 SPINDLE.
Let us suppose a single-channel machine with three axes and one spindle and two axes that
have not been assigned initially. The axes and spindles are distributed as follows.
General configuration of the channels, axes and spindles.
Configuration of the axes and spindles of the system.
Configuration of the axes and spindles of channel ·1·.
Plane selection in channel ·1·.
Channel ·1·. 3 axes (X Y Z) 1 spindle (S).
Not assigned. 2 axes (A B)
System Channel ·1·
NCHANNEL = 1
NAXIS = 5 CHNAXIS = 3
NSPDL = 1 CHNSPDL = 1
AXISNAME Value. Logic order. Index in the system.
AXISNAME 1 X Logic number ·1·.
AXISNAME 2 Y Logic number ·2·.
AXISNAME 3 Z Logic number ·3·.
AXISNAME 4 A Logic number ·4·.
AXISNAME 5 B Logic number ·5·.
SPDLNAME 1 S1 Logic number ·6·. Spindle with index ·1·.
CHAXISNAME Value. Index in the channel. Logic order.
CHAXISNAME 1 X Axis with index ·1·. Logic number ·1·.
CHAXISNAME 2 Y Axis with index ·2·. Logic number ·2·.
CHAXISNAME 3 Z Axis with index ·3·. Logic number ·3·.
CHSPDLNAME Value. Index in the channel. Logic order.
CHSPDLNAME 1 S Spindle with index ·1·. Logic number ·10·.
Function. Selected plane.
G17 X-Y plane. Perpendicular axis Z.
G18 Z-X plane. Perpendicular axis Y.
G19 Y-Z plane. Perpendicular axis X.
G20 Any plane and/or longitudinal axis.