Fagor CNC 8060 - Page 496

·496·
Installation manual
CNC 8060
CNC 8065
9.
CONCEPTS.
(REF: 1402)
Configuration of the HSC mode (High Speed Cutting).
VARIABLES ASSOCIATED WITH THE VELOCITY IN THE
LOOP.
(V.)[ch].A.TFEED.xn
(V.)[ch].A.TFEED.sn
(V.)[ch].SP.TFEED.sn
Instantaneous theoretical speed value at the input of the position loop.
(V.)[ch].A.FEED.xn
(V.)[ch].A.FEED.sn
(V.)[ch].SP.FEED.sn
Instantaneous real speed value at the input of the position loop.
VARIABLES ASSOCIATED WITH THE VELOCITY COMMAND
AND THE FEEDBACK.
(V.)[ch].A.POSCMD.xn
(V.)[ch].A.POSCMD.sn
(V.)[ch].SP.POSCMD.sn
Position command for Sercos.
(V.)[ch].A.POSNC.xn
(V.)[ch].A.POSNC.sn
(V.)[ch].SP.POSNC.sn
Position feedback.
(V.)[ch].A.FTEO.xn
(V.)[ch].A.FTEO.sn
(V.)[ch].SP.FTEO.sn
Velocity command for Sercos (in rpm).