Installation manual
CNC 8060
CNC 8065
MACHINE PARAMETERS.
2.
(REF: 1402)
·53·
General machine parameters.
WARNCOUPE
Gantry axis. Difference between the following errors of both axes
for issuing a warning.
Possible values: From 0.0001 to 99999.9999 mm or degrees / from 0 to 3937.00787 inch.
Default value: 1.0000 mm or degrees / 0.03937 inch.
Associated variable: (V.)MPG.WARNCOUPE[nb]
Parameter included in the GANTRY table.
This parameter sets the maximum difference allowed between the following errors of both
axes before issuing a warning. This warning lets the user act upon the machine before the
CNC issues the error.
The value of parameter WARNCOUPE must be lower than that of parameter MAXCOUPE.
MAXCOUPE
Gantry axis. Maximum difference allowed between the following
errors of both axes.
Possible values: From 0.0001 to 99999.9999 mm or degrees / from 0 to 3937.00787 inch.
Default value: 1.0000 mm or degrees / 0.03937 inch.
Associated variable: (V.)MPG.MAXCOUPE[nb]
Parameter included in the GANTRY table.
This parameter indicates the maximum difference allowed between the following errors of
both axes. If the difference exceeds this value, the CNC will display an error message.
DIFFCOMP
Gantry axis. Compensate for the coordinate (position) difference
between the two axes after G74.
Possible values: Yes / No.
Default value: Yes.
Associated variable: (V.)MPG.DIFFCOMP[nb]
Parameter included in the GANTRY table.
This parameter enables the correction of the position difference between the master and the
slave axes after homing. The correction of the position difference is applied using the mark
DIFFCOMP(axis).
To compensate the position value, the slave axis will move until reaching the position of the
master axis at the feedrate set by parameter REFFEED2. This process can only be
interrupted with RESET.
MAXDIFF
Gantry axis. Maximum position value (coordinate) difference
between both axes to compensate for.
Possible values: From 0 to 99999.9999 mm or degrees / from 0 to 3937.00787 inch.
Default value: 0.0000 mm, degrees or inches.
Associated variable: (V.)MPG.MAXDIFF[nb]
Parameter included in the GANTRY table.
To avoid correcting coordinate differences that are too big between the master and the slave
axes, this parameter sets the maximum coordinate difference allowed to be corrected
between both axes. The CNC will only correct the coordinate difference when it is smaller
than the value set in this parameter.
To Next Page
Loading...
