Fagor CNC 8060 - Page 546

·546·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables related to general machine parameters.
The variable will return a ·0· value if the table has not been defined.
Syntax.
·tbl· Table number.
(V.)MPG.NPCROSS[tbl]
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Cross compensation table [tbl]. Number of points in the table.
Syntax.
·tbl· Table number.
(V.)MPG.TYPCROSS[tbl]
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Cross compensation table [tbl]. Type of compensation (type of coordinates).
Syntax.
·tbl· Table number.
Values of the variable.
This variable returns one of the following values.
(V.)MPG.BIDIR[tbl]
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Cross compensation table [tbl]. Bi-directional compensation.
When using bi-directional compensation, the table permits using a different compensation
for each moving direction. If the compensation is not bidirectional, it applies the same
compensation in both directions.
Syntax.
·tbl· Table number.
Values of the variable.
This variable returns one of the following values.
V.MPG.COMPAXIS[3] Third cross compensation table.
V.MPG.NPCROSS[3] Third cross compensation table.
V.MPG.TYPCROSS[3] Third cross compensation table.
Value. Meaning.
0 Compensation is applied using real
coordinates.
1 Compensation is applied using theoretical
coordinates.
V.MPG.BIDIR[3] Third cross compensation table.
Value. Meaning.
0No.
1Yes.