Fagor CNC 8060 - Page 55

Installation manual
CNC 8060
CNC 8065
MACHINE PARAMETERS.
2.
(REF: 1402)
·55·
General machine parameters.
MULNAXIS
Number of axes and/or spindles making up the multi-axis group.
Possible values: From 1 to 8.
Default value: 2.
Associated variable: (V.)MPG.MULNAXIS[nb]
Parameter included in the MULTIAXIS // GROUP n table.
This parameter sets the number of axes and/or spindles making up the multi-axis group.
Since each axis or spindle of the CNC can have several parameter sets, the number of axes
of the group is limited by the 8 parameter sets available at the drive. The parameter sets of
the drive are distributed among all the axes and/or spindles that make up the multi-axis group,
so a group may be formed by 8 axes with 1 parameter set for each, 1 spindle with 4 sets plus
2 axes with 2 sets each, etc.
MULAXISNAME n
Name of the axes and/or spindles of the group.
Possible values: Any Sercos axis of the system, except tandem or gantry axes
Associated variable: (V.)MPG.MULAXISNAMExn[nb]
Parameter included in the MULTIAXIS // GROUP n table.
Any Sercos axis of the system may be part of a group, except those that belong to gantry
or tandem axes. The first axis of the group will be the master axis, the one the drive will use
by default; the order of the rest of the axes is irrelevant. On system power-up, the CNC will
use the parameters of the master axis to run the parameter matching with the drive.
CONFIGURING THE SPINDLES OF THE SYSTEM
NSPDL
Number of spindles governed by the CNC.
Possible values: From 0 to 4.
Default value: 1.
Associated variable: (V.)MPG.NSPDL
This parameter sets the number of spindles of the system, whether they are servo-controlled
or not.
Bear in mind that the number of spindles does not depend on the number of channels. A
channel may have one, several or no spindles associated with it.
SPDLNAME
List of spindles of the system.
This parameter shows the table to define the names of the spindles. Parameter NSPDL sets
the number of spindles of the system.
SPDLNAME n
Name of the spindles.
Possible values: S, S1··S9.
Default value: Starting from SPDLNAME1; S, S1...
Associated variable: (V.)MPG.SPDLNAMEn
Parameter included in the SPDLNAME table.
The spindle name is defined by 1 or 2 characters. The first character must be the letter -S-
. The second character is optional and will be a numerical suffix between 1 and 9. This way,
the name of the spindles may be within the range S, S1 ... S9.
SPDLNAME
SPDLNAME n Name of the spindles.