·570·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables related to the machine parameters of the channels.
Syntax.
·ch· Channel number.
(V.)[ch].MPG.ROUNDFEED
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Percentage of feedrate in G5.
Syntax.
·ch· Channel number.
ARC CENTER CORRECTION.
(V.)[ch].MPG.CIRINERR
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Maximum absolute radius error permitted.
Syntax.
·ch· Channel number.
(V.)[ch].MPG.CIRINFACT
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Maximum relative radius error permitted.
The relative error is given as a percentage over the radius.
Syntax.
·ch· Channel number.
Remarks.
The reading from the PLC will be given in tenths (x10); i.e. if the parameter value is ·10·, the
PLC reading will return a value of ·100·.
BEHAVIOR OF THE FEEDRATE AND THE FEEDRATE
OVERRIDE.
(V.)[ch].MPG.MAXOVR
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Maximum override (%) permitted.
Syntax.
·ch· Channel number.
V.[2].MPG.MAXROUND Channel ·2·.
V.[2].MPG.ROUNDFEED Channel ·2·.
V.[2].MPG.CIRINERR Channel ·2·.
V.[2].MPG.CIRINFACT Channel ·2·.
V.[2].MPG.MAXOVR Channel ·2·.
To Next Page
Loading...
