Fagor CNC 8060 - Page 618

·618·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables related to the sets of machine parameters.
(V.)[ch].MPA.OUTPUTREV[set].xn
(V.)[ch].MPA.OUTPUTREV[set].sn
(V.)[ch].SP.OUTPUTREV[set].sn
Variable that can only be read from the program, PLC and interface.
Variable that may be modified during setup.
Variable valid for rotary and linear axes as well as for spindles.
Variable valid for analog drive, position Sercos and velocity Sercos.
The variable returns the execution value; reading it interrupts block preparation.
Gear ratio; turns of the machine shaft.
Syntax.
·ch· Channel number.
·set· Parameter set.
·xn· Name, logic number or index of the axis.
·sn· Name, logic number or index of the spindle.
(V.)[ch].MPA.NPULSES[set].xn
(V.)[ch].MPA.NPULSES[set].sn
(V.)[ch].SP.NPULSES[set].sn
Variable that can only be read from the program, PLC and interface.
Variable that may be modified during setup.
Variable valid for rotary and linear axes as well as for spindles.
Variable valid for analog drives and velocity-Sercos drives.
The variable returns the execution value; reading it interrupts block preparation.
Number of encoder pulses.
With linear encoders (scales), this parameter will be set to ·0·. When using a gear reduction
on the axis, the whole assembly must be taken into account when defining the number of
pulses per turn.
Syntax.
·ch· Channel number.
·set· Parameter set.
·xn· Name, logic number or index of the axis.
·sn· Name, logic number or index of the spindle.
V.[2].MPA.INPUTREV[3].1 Axis with index ·1· in the channel ·2·.
V.SP.INPUTREV[3].2 Spindle with index ·2· in the system.
V.[2].SP.INPUTREV[3].1 Spindle with index ·1· in the channel ·2·.
V.MPA.OUTPUTREV[3].Z Z axis.
V.MPA.OUTPUTREV[3].S Spindle S.
V.SP.OUTPUTREV[3].S Spindle S.
V.SP.OUTPUTREV[3] Master spindle.
V.MPA.OUTPUTREV[3].4 Axis or spindle with logic number ·4·.
V.[2].MPA.OUTPUTREV[3].1 Axis with index ·1· in the channel ·2·.
V.SP.OUTPUTREV[3].2 Spindle with index ·2· in the system.
V.[2].SP.OUTPUTREV[3].1 Spindle with index ·1· in the channel ·2·.
V.MPA.NPULSES[3].Z Z axis.
V.MPA.NPULSES[3].S Spindle S.
V.SP.NPULSES[3].S Spindle S.
V.SP.NPULSES[3] Master spindle.
V.MPA.NPULSES[3].4 Axis or spindle with logic number ·4·.
V.[2].MPA.NPULSES[3].1 Axis with index ·1· in the channel ·2·.
V.SP.NPULSES[3].2 Spindle with index ·2· in the system.
V.[2].SP.NPULSES[3].1 Spindle with index ·1· in the channel ·2·.