Fagor CNC 8060 - Page 642

·642·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables related to the sets of machine parameters.
CONFIGURATION OF THE HSC MODE.
(V.)[ch].MPA.CORNERACC[set].xn
(V.)[ch].MPA.CORNERACC[set].sn
(V.)[ch].SP.CORNERACC[set].sn
Variable that can only be read from the program, PLC and interface.
Variable valid for rotary and linear axes as well as for spindles.
Variable valid for analog drive, position Sercos and velocity Sercos.
The variable returns the value of block preparation.
Maximum acceleration permitted at the corners.
Syntax.
·ch· Channel number.
·set· Parameter set.
·xn· Name, logic number or index of the axis.
·sn· Name, logic number or index of the spindle.
(V.)[ch].MPA.CURVACC[set].xn
(V.)[ch].MPA.CURVACC[set].sn
(V.)[ch].SP.CURVACC[set].sn
Variable that can only be read from the program, PLC and interface.
Variable valid for rotary and linear axes as well as for spindles.
Variable valid for analog drive, position Sercos and velocity Sercos.
The variable returns the value of block preparation.
Maximum contouring acceleration permitted.
Syntax.
·ch· Channel number.
·set· Parameter set.
·xn· Name, logic number or index of the axis.
·sn· Name, logic number or index of the spindle.
V.MPA.CORNERACC[3].Z Z axis.
V.MPA.CORNERACC[3].S Spindle S.
V.SP.CORNERACC[3].S Spindle S.
V.SP.CORNERACC[3] Master spindle.
V.MPA.CORNERACC[3].4 Axis or spindle with logic number ·4·.
V.[2].MPA.CORNERACC[3].1 Axis with index ·1· in the channel ·2·.
V.SP.CORNERACC[3].2 Spindle with index ·2· in the system.
V.[2].SP.CORNERACC[3].1 Spindle with index ·1· in the channel ·2·.
V.MPA.CURVACC[3].Z Z axis.
V.MPA.CURVACC[3].S Spindle S.
V.SP.CURVACC[3].S Spindle S.
V.SP.CURVACC[3] Master spindle.
V.MPA.CURVACC[3].4 Axis or spindle with logic number ·4·.
V.[2].MPA.CURVACC[3].1 Axis with index ·1· in the channel ·2·.
V.SP.CURVACC[3].2 Spindle with index ·2· in the system.
V.[2].SP.CURVACC[3].1 Spindle with index ·1· in the channel ·2·.