Fagor CNC 8060 - Page 680

·680·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables related to kinematic machine parameters.
Syntax.
·ang· Number of the angular transformation.
Remarks.
The logic number of the axes is determined by the order in which the axes have been defined
in the machine parameter table. The first axis of the table will be logic axis -1- and so on.
(V.)MPK.ANGANTR[ang]
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Angular transformation [ang]. Angle between the Cartesian axis and the incline axis.
Syntax.
·ang· Number of the angular transformation.
(V.)MPK.OFFANGAX[ang]
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Angular transformation [ang]. Offset of the origin of the angular transformation.
Syntax.
·ang· Number of the angular transformation.
V.MPK.ORTAXNA[2] Angular transformation ·2·.
V.MPK.ORTAXNA[2] Angular transformation ·2·.
V.MPK.OFFANGAX[2] Angular transformation ·2·.