Fagor CNC 8060 - Page 718

·718·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
PLC modifiable logic signals; general.
(V.)PLC.NEXTMPGAXIS
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
Every time the PLC turns this mark on, the CNC selects an axis to be moved with the
handwheel.
(V.)PLC.PANELOFF1
(V.)PLC.PANELOFF2
(V.)PLC.PANELOFF3
(V.)PLC.PANELOFF4
(V.)PLC.PANELOFF5
(V.)PLC.PANELOFF6
(V.)PLC.PANELOFF7
(V.)PLC.PANELOFF8
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
If the PLC activates one of these marks the CNC disables the corresponding jog panel.
(V.)PLC.SYNC
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The PLC indicates in this register the spindle to be used for synchronization.
The channel uses this spindle with function G33 to thread a particular spindle and with G95
to program the feedrate according to a particular spindle.
(V.)PLC.RETRACE
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
If the PLC turns this mark on while a program is being executed, the channel turns the retrace
function on.
V.PLC.NEXTMPGAXIS
V.PLC.PANELOFF1 Disable operator panel ·1·.
V.PLC.PANELOFF2 Disable operator panel ·2·.
V.PLC.SYNC1 Channel ·1·.
V.PLC.SYNC2 Channel ·2·.
V.PLC.SYNC3 Channel ·3·.
V.PLC.SYNC4 Channel ·4·.
V.PLC.RETRACEC1 Channel ·1·.
V.PLC.RETRACEC2 Channel ·2·.
V.PLC.RETRACEC3 Channel ·3·.
V.PLC.RETRACEC4 Channel ·4·.