·72·
Installation manual
CNC 8060
CNC 8065
2.
MACHINE PARAMETERS.
(REF: 1402)
General machine parameters.
output if it is active. Once the PWM is deactivated for some error, that PWM will not be
reactivated when the error disappears; therefore, they have to be reactivated either by
program or via PLC.
BACKUP OF NON-VOLATILE DATA.
BKUPREG
Number of non-volatile PLC registers.
Possible values: From 0 to 20.
Default value: 0.
Associated variable: (V.)MPG.BKUPREG
This parameter indicates the number of PLC registers that are saved in RAM memory with
a battery. The CNC saves the first registers, from the first one to the one set in this parameter.
Non-volatile data means that their values must be maintained from one session to another
and after turning the CNC off. The CNC saves this data when the CNC is turned off, when
power is removed, when a hardware error occurs, etc.
BKUPCOUN
Number of non-volatile PLC counters.
Possible values: From 0 to 20.
Default value: 0.
Associated variable: (V.)MPG.BKUPCOUN
This parameter indicates the number of PLC counters that are saved in RAM memory with
a battery. The CNC saves the first counters, from the first one to the one set in this parameter.
Non-volatile data means that their values must be maintained from one session to another
and after turning the CNC off. The CNC saves this data when the CNC is turned off, when
power is removed, when a hardware error occurs, etc.
TOOL OFFSET AND WEAR.
TOOLOFSG
Sign criteria for tool offsets and tool wear
Possible values: Positive / Negative.
Default value: Negative.
Associated variable: (V.)MPG.TOOLOFSG
This parameter sets the sign criteria for the offsets and their wear. The offsets are used to
define the tool dimensions in each axis. The dimensions of the turning tools are defined using
these offsets; either these offsets or tool length and radius may be used for the dimensions
of the rest of the tools.
TOOLOFSG Meaning.
Negative. Tool calibration returns a negative offset. The offset wear
must be entered with a positive value.
Positive. Tool calibration returns a positive offset. The offset wear
must be entered with a negative value.
To Next Page
Loading...
