Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·789·
Feedrate related variables.
Remarks.
Regardless of the value assigned to this variable, the feedrate will never exceed the limits
set by parameters G00FEED and MAXFEED.
PROGRAMMING THE FEEDRATE IN G94.
(V.)[ch].G.FEED
Variable that can only be read from the program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
Channel [ch]. Feedrate active in G94.
Syntax.
·ch· Channel number.
Remarks.
The feedrate in G94 may be set by program or by PLC; the one set by PLC has the highest
priority.
(V.)[ch].PLC.F
Variable that can be read and written from the PLC and read from the program and from the interface.
The variable returns the execution value; reading it interrupts block preparation.
Channel [ch]. Feedrate by PLC in G94.
The feedrate programmed by PLC prevails over the one programmed by program or MDI.
To cancel the feedrate by PLC, set the variable to ·0·; the CNC applies the feedrate active
by program.
Syntax.
·ch· Channel number.
Variable. Machine parameters. Feedrate active in the channel.
(V.)[ch].PLC.G00FEED G00FEED MAXFEED G00 G01, G02, ···
3000 10000 5000 3000 3000
7000 10000 5000 7000 5000
12000 10000 5000 10000 5000
V.[2].G.FEED Channel ·2·.
Feedrates set. (V.)[ch].PLC.F (V.)[ch].G.PRGF (V.)[ch].G.FEED
By program; F2000.
By PLC; none.
0 2000 2000
By program; F2000.
By PLC; F4000.
4000 2000 4000
By program; F2000.
By PLC; F500.
500 2000 500
By program; F2000.
By PLC; none.
By MDI; F3000.
0 3000 3000
By program; F2000.
By PLC; F6000.
By MDI; F3000.
6000 3000 6000
By program; F2000.
By PLC; F500.
By MDI; F3000.
500 3000 500
V.[2].PLC.F Channel ·2·.
To Next Page
Loading...
