Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·795·
Variables related to managing the feedrate in HSC mode.
Syntax.
·ch· Channel number.
Values of the variable.
This variable returns one of the following values.
(V.)[ch].G.ACTROUND
Variable that can only be read from the program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
Error programmed in HSC mode.
This variable may be used to optimize the OEM subroutines by cancelling the HSC mode
and activating G5 with another error to save time and restore the previous execution mode
later one.
Syntax.
·ch· Channel number.
FEEDRATE LIMITATION AT THE BLOCK BEING EXECUTED.
(V.)[ch].G.AXLIMF
Variable that can only be read from the program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
Logic number of the axis that limits the feedrate at the block being executed.
Together with the V.G.PARLIMF variable, it may be used to evaluate the behavior of the
machining operation in a particular section where the feedrate decreases too much or is
irregular.
Syntax.
·ch· Channel number.
(V.)[ch].G.PARLIMF
Variable that can only be read from the program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
Cause that limits the feedrate at the block being executed.
Syntax.
·ch· Channel number.
V.[2].G.LIMERROR Channel ·2·.
Value. Meaning.
-1 The generated profile does not exceed the programmed error. The programmed error
does not limit the maximum feedrate of the axis.
### Value of the error that cancels the splines (CONTERROR mode).
V.[2].G.ACTROUND Channel ·2·.
V.[2].G.AXLIMF Channel ·2·.
V.[2].G.PARLIMF Channel ·2·.
To Next Page
Loading...
