Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·797·
Variables related to managing the feedrate in HSC mode.
MODIFY THE DYNAMICS OF ALL THE AXES OF THE
CHANNEL.
(V.)[ch].G.DYNOVR
Variable that can be read and written via program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
Percentage applicable to all the dynamics variables of all the axes of the channel.
This variable may be used to make changes in real time to the machining dynamics (ignoring
look-ahead blocks). The dynamics can also be changed from the interface using the
dynamic-override bar of the HSC.
The upper and lower limits (range) for varying the value depends on machine parameters
MINDYNOVR and MAXDYNOVR.
Syntax.
·ch· Channel number.
V.[2].G.DYNOVR Channel ·2·.
To Next Page
Loading...
