·8·
Installation manual
CNC 8060
CNC 8065
(REF: 1402)
SOFTWARE OPTIONS.
Bear in mind that some of the features described in this manual depend on the software options that are
installed. The information of the following table is informative only; when purchasing the software options,
only the information provided in the ordering handbook is valid.
Software options (·M· model).
8060 M 8065 M 8065 M Power
Basic Pack 1 Basic Pack 1
Open system.
Access to the administrator mode.
- - - - - - - - - Option Option
Number of execution channels 1 1 1 1 1 to 4
Number of axes 3 a 5 3 to 6 5 to 8 5 to 12 8 to 28
Number of spindles 1 1 1 to 2 1 to 4 1 to 4
Number of tool magazines 1 1 1 1 to 2 1 to 4
Limited to 4 interpolated axes Option Option Option Option Option
IEC 61131 language - - - - - - Option Option Option
HD graphics Option Option Option Standard Standard
Conversational IIP Option Option Option Option Option
Dual-purpose machines (M-T) - - - - - - - - - Option Standard
"C" axis Option Standard Standard Standard Standard
Dynamic RTCP Option - - - Option Option Standard
HSSA machining system. Option Standard Standard Standard Standard
Probing canned cycles Option Option Standard Standard Standard
Tandem axes Option - - - Option Standard Standard
Synchronism and cams - - - - - - - - - Option Standard
Tangential control - - - - - - Standard Standard Standard
Volumetric compensation (up to 10 m³). - - - - - - - - - Option Option
Volumetric compensation (more than 10 m³). - - - - - - - - - Option Option
ProGTL3 language. Option Option Option Option Option
Part-program translator. Option Option Option Option Option
To Next Page
Loading...
