·80·
Installation manual
CNC 8060
CNC 8065
2.
MACHINE PARAMETERS.
(REF: 1402)
General machine parameters. Execution channels.
When defining the spindles, bear in mind that the order in which they are defined determines
their index in the channel. The index of the first spindle of the table will be ·1· and so on. As
with the spindle name, the index in the channel permits identifying the spindle in PLC
variables, marks, etc.
CONFIGURATION OF THE C AXIS.
CAXNAME
Default name of the C axis.
Possible values: Any valid axis name; X, X1··X9, ·· , C, C1··C9.
Default value: C.
Associated variable: (V.)[ch].MPG.CAXNAME
This parameter must be defined whenever there is an axis or spindle set as C axis.
When setting more than one C axis, use the program instruction #CAX to indicate the one
that is active. Only one C axis may be active in each channel.
ALIGNC
"C" axis alignment for diametrical machining.
Possible values: Yes / No.
Default value: Yes.
Associated variable: (V.)[ch].MPG.ALIGNC
This parameter indicates whether the tool can machine the whole surface diametrically in
a single run (ALIGNC = No) or the "C" axis must be aligned (ALIGNC = Yes).
TIME SETTING (CHANNEL).
PREPFREQ
Maximum number of blocks to prepare per cycle.
Possible values: From 1 to 8.
Default value: 1.
Associated variable: (V.)[ch].MPG.PREPFREQ
While executing a program, the CNC reads in advance the blocks to be executed in order
to calculate the path to follow; this is known as block preparations. The number of blocks to
be prepared depends on the type of machining operation; it is not the same to process blocks
CHSPDLNAME Index in the channel.
CHSPDLNAME 1 Index ·1·.
CHSPDLNAME 2 Index ·2·.
CHSPDLNAME 3 Index ·3·.
ALIGNC Meaning.
Ye s .
(1) Machining up to the center.
(2) Rotate the "C" axis 180°.
(3) Resume machining by moving the tool back.
No.
To Next Page
Loading...
