Fagor CNC 8060 - Page 803

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·803·
Variables related to spindle speed.
(V.)[ch].PLC.SL.sn
Variable that can be read and written from the PLC and read from the program and from the interface.
The variable returns the execution value; reading it interrupts block preparation.
Channel [ch]. Spindle speed limit active by PLC.
The speed programmed by PLC prevails over the one programmed by program or MDI. To
cancel the speed by PLC, set the variable to ·0·; the CNC applies the speed active by
program.
Syntax.
·ch· Channel number.
·sn· Name, logic number or index of the spindle.
(V.)[ch].A.PRGSL.sn
(V.)[ch].SP.PRGSL.sn
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Spindle speed limit active by program.
Syntax.
·ch· Channel number.
·sn· Name, logic number or index of the spindle.
PERCENTAGE OF SPINDLE SPEED (SPINDLE SPEED
OVERRIDE).
(V.)[ch].A.SSO.sn
(V.)[ch].SP.SSO.sn
Variable that can only be read from the program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
Channel [ch]. Active spindle speed override.
Syntax.
·ch· Channel number.
·sn· Name, logic number or index of the spindle.
V.PLC.SL.S2 Spindle S2.
V.PLC.SL.5 Spindle with logic number ·5·.
V.[2].PLC.SL.1 Spindle with index ·1· in the channel ·2·.
V.A.PRGSL.S Spindle S.
V.SP.PRGSL.S Spindle S.
V.SP.PRGSL Master spindle.
V.A.PRGSL.5 Spindle with logic number ·5·.
V.SP.PRGSL.2 Spindle with index ·2· in the system.
V.[2].SP.PRGSL.1 Spindle with index ·1· in the channel ·2·.
V.A.SSO.S Spindle S.
V.SP.SSO.S Spindle S.
V.SP.SSO Master spindle.
V.A.SSO.5 Spindle with logic number ·5·.
V.SP.SSO.2 Spindle with index ·2· in the system.
V.[2].SP.SSO.1 Spindle with index ·1· in the channel ·2·.