Fagor CNC 8060 - Page 808

·808·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables related to managing the tool magazine and the tool
changer arm.
10.48 Variables related to managing the tool magazine and the tool
changer arm.
RELATIONSHIP BETWEEN THE TOOL MAGAZINE AND THE
CHANNEL.
(V.)[ch].TM.ACTUALMZ
Variable that can only be read from the program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
Tool Magazine being used by the [ch] channel.
Syntax.
·ch· Channel number.
(V.)TM.MZACTUALCH[mz]
Variable that can only be read from the program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
Channel that is using tool magazine [mz].
Syntax.
·mz· Type of tool magazine.
TOOL LOCATION IN THE MAGAZINE.
(V.)TM.T[mz][pos]
Variable that can only be read from the program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
Tool in the [pos] position of the [mz] magazine.
Syntax.
·mz· Type of tool magazine.
·pos· Tool position in the magazine.
Remarks.
If the variable is missing the offset number, the variable will then refer to the first one. This
variable returns 0 if the tool is not in the magazine.
(V.)TM.P[mz][tl]
Variable that can only be read from the program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
Position of the [t] tool in the [mz] magazine.
Syntax.
·mz· Type of tool magazine.
·tl· Tool number.
V.[2].TM.ACTUALMZ Channel ·2·.
V.TM.MZACTUALCH[2] Magazine ·2·.
V.TM.T[2][15] Magazine ·2·. Position ·15·.
V.TM.P[2][15] Magazine ·2·. Position ·15·.