Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·813·
Variables related to the active tool and to the next one.
TOOL GEOMETRY.
(V.)[ch].TM.NUMOFD
Variable that can only be read from the program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
Active tool. Number of tool offsets.
Syntax.
·ch· Channel number.
(V.)[ch].TM.DTYPE[ofd]
Variable that can be read and written via program, PLC(asynchronous writing) and interface.
The variable returns the execution value; reading it interrupts block preparation.
Active tool. Code of the tool offset type.
Syntax.
·ch· Channel number.
[odf] Tool offset; if missing, the active tool offset.
Values of the variable.
This variable returns one of the following values.
(V.)[ch].TM.DSUBTYPE[ofd]
Variable that can be read and written via program, PLC(asynchronous writing) and interface.
The variable returns the execution value; reading it interrupts block preparation.
Active tool. Code of the tool offset subtype.
Syntax.
·ch· Channel number.
[odf] Tool offset; if missing, the active tool offset.
V.[2].TM.NUMOFD Channel ·2·.
V.[2].TM.DTYPE Channel ·2·. Active tool offset.
V.[2].TM.DTYPE[3] Channel ·2·. Tool offset ·3·.
Value. Meaning.
1 Milling tool..
2 Drilling tool.
3 Surface milling tool.
4 Reaming tool.
5 Boring tool.
6 Threading tool.
7 Grooving or cut-off tool.
8 Turning tool.
9 Other.
10 Measuring probe.
V.[2].TM.DSUBTYPE Channel ·2·. Active tool offset.
V.[2].TM.DSUBTYPE[3] Channel ·2·. Tool offset ·3·.
To Next Page
Loading...
