Fagor CNC 8060 - Page 815

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·815·
Variables related to the active tool and to the next one.
Values of the variable.
This variable returns one of the following values.
(V.)[ch].TM.LOCODE[ofd]
Variable that can be read and written via program, PLC(asynchronous writing) and interface.
The variable returns the execution value; reading it interrupts block preparation.
[odf] offset of the active tool. Location code (shape) or tool calibration point.
Only for turning tools. The location code indicates which is the calibrated tool tip and,
therefore, the point controlled by the CNC to apply radius compensation. The location code
depends on the orientation of the machine axes.
Syntax.
·ch· Channel number.
[odf] Tool offset; if missing, the active tool offset.
Values of the variable.
This variable returns one of the following values.
Value. Axis orientation. Value. Axis orientation.
04
15
26
37
V.[2].TM.LOCODE Channel ·2·. Active tool offset.
V.[2].TM.LOCODE[3] Channel ·2·. Tool offset ·3·.
Value.
0
1
2
3
4
5
6