Fagor CNC 8060 - Page 828

·828·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables associated with any tool.
Syntax.
·tl· Tool number.
[odf] Tool offset; if missing, the active tool offset.
(V.)TM.TOIT[tl][ofd]
Variable that can be read and written via program, PLC(asynchronous writing) and interface.
The variable returns the execution value; reading it interrupts block preparation.
[odf] offset of the [tl] tool. Radius wear.
This variable is not valid for turning tools.
Syntax.
·tl· Tool number.
[odf] Tool offset; if missing, the active tool offset.
(V.)TM.TOLT[tl][ofd]
Variable that can be read and written via program, PLC(asynchronous writing) and interface.
The variable returns the execution value; reading it interrupts block preparation.
[odf] offset of the [tl] tool. Length.
This variable is not valid for turning tools.
Syntax.
·tl· Tool number.
[odf] Tool offset; if missing, the active tool offset.
(V.)TM.TOKT[tl][ofd]
Variable that can be read and written via program, PLC(asynchronous writing) and interface.
The variable returns the execution value; reading it interrupts block preparation.
[odf] offset of the [tl] tool. Length wear.
This variable is not valid for turning tools.
Syntax.
·tl· Tool number.
[odf] Tool offset; if missing, the active tool offset.
(V.)TM.TOANT[tl][ofd]
Variable that can be read and written via program, PLC(asynchronous writing) and interface.
The variable returns the execution value; reading it interrupts block preparation.
[odf] offset of the [tl] tool. Penetration angle.
Syntax.
·tl· Tool number.
V.TM.TORT[23] Tool ·23·. Active tool offset.
V.TM.TORT[23][3] Tool ·23·. Tool offset ·3·.
V.TM.TOIT[23] Tool ·23·. Active tool offset.
V.TM.TOIT[23][3] Tool ·23·. Tool offset ·3·.
V.TM.TOLT[23] Tool ·23·. Active tool offset.
V.TM.TOLT[23][3] Tool ·23·. Tool offset ·3·.
V.TM.TOKT[23] Tool ·23·. Active tool offset.
V.TM.TOKT[23][3] Tool ·23·. Tool offset ·3·.