Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·841·
Variables related to jog mode.
Remarks.
The type of movement may be set by the switch of the operator panel or by PLC; the one
set by PLC has the highest priority.
(V.)[ch].A.CNCMMODE.xn
Variable that can be read and written from the interface and read from the program and from the PLC.
Variable valid for rotary and linear axes.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
Type of movement selected at the switch for the ·xn· axis.
The value set by the switch of the operator panel has lower priority than the one set by PLC.
Syntax.
·ch· Channel number.
·xn· Name, logic number or index of the axis.
Values of the variable.
This variable returns one of the following values.
(V.)[ch].A.PLCMMODE.xn
Variable that can be read and written from the PLC and read from the program and from the interface.
Variable valid for rotary and linear axes.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
Type of movement selected by PLC for the ·xn· axis.
The value selected by PLC prevails over the one selected on the operator panel. To cancel
the feedrate set by PLC, set the variable to ·0·.
Syntax.
·ch· Channel number.
·xn· Name, logic number or index of the axis.
Values of the variable.
This variable returns one of the following values.
V.A.CNCMMODE.Z Z axis.
V.A.CNCMMODE.4 Axis with logic number ·4·.
V.[2].A.CNCMMODE.1 Axis with index ·1· in the channel ·2·.
Value. Meaning.
1 Handwheel mode.
2 Continuous jog mode.
3 Incremental jog mode.
V.A.PLCMMODE.Z Z axis.
V.A.PLCMMODE.4 Axis with logic number ·4·.
V.[2].A.PLCMMODE.1 Axis with index ·1· in the channel ·2·.
Value. Meaning.
0 Nothing has been selected by PLC.
1 Handwheel mode.
2 Continuous jog mode.
3 Incremental jog mode.
To Next Page
Loading...
