Fagor CNC 8060 - Page 852

·852·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables related to the programmed functions.
Remarks.
(V.)C.name
Variable that can be read and written from the program.
The variable returns the value of block preparation.
Value of the parameters that call upon the canned cycles of the editor.
Syntax.
·name·Call parameter.
(V.)C.CALLP_A··Z
Variable that can be read from the program.
The variable returns the value of block preparation.
Parameter programmed in the call to a canned cycle.
Syntax.
·A··Z· Call parameter.
Values of the variable.
This variable returns one of the following values.
Remarks.
(V.)C.P_A··Z
Variable that can be read and written from the program.
The variable returns the value of block preparation.
Value of the positioning cycle calling parameter.
Syntax.
·A··Z· Call parameter.
Calling a canned cycle. Reading the variable.
G90 G81 Z0 I-15 V.C.Z = 0
V.C.Z = -15
V.C.MROUGHIN Parameter MROUGHIN.
V.C.CALLP_F "F" parameter.
Value. Meaning.
0 It has not been programmed.
1 It has been programmed.
Calling a canned cycle. Reading the variable.
G90 G81 Z0 I-15 V.C.CALLP_Z = 1
V.C.CALLP_I = 1
V.C.CALLP_K = 0
V.C.P_F "F" parameter.