Fagor CNC 8060 - Page 87

Installation manual
CNC 8060
CNC 8065
MACHINE PARAMETERS.
2.
(REF: 1402)
·87·
General machine parameters. Execution channels.
IFEED
Type of feedrate (G94/G95) by default.
Possible values: G94 / G95.
Default value: G94.
Associated variable: (V.)[ch].MPG.IFEED
This parameter indicates the type of feedrate assumed by the CNC by default.
• With G94, the feedrate is assumed in mm/min or degrees/min or inches/min.
• With G95, the feedrate is assumed in mm/rev or degrees/rev or inches/rev.
The typical configuration for the mill model will be G94. The typical configuration for the lathe
model will be G95.
To change the type of feedrate via part-program, use function G93 or G94.
FPRMAN
Function G95 admitted in jog mode.
Possible values: Yes / No.
Default value: No.
Associated variable: (V.)[ch].MPG.FPRMAN
This parameter indicates whether function G95 (feedrate in mm/rev or inches/rev) is admitted
in jog mode or not.
IRCOMP
Tool radius compensation mode (G136/G137) by default.
Possible values: G136 / G137.
Default value: G136.
Associated variable: (V.)[ch].MPG.IRCOMP
This parameter indicates the compensation mode assumed by the CNC by default. Being
the radius compensation active, the compensated paths may be blended together using
circular paths (G136) or linear paths (G137).
To change the type of compensation via part-program, use function G136 or G137.
COMPCANCEL
How to cancel tool radius compensation.
Possible values: With motion / Without motion.
Default value: Without motion
Associated variable: (V.)[ch].MPG.COMPCANCEL
This parameter indicates whether tool radius compensation is canceled in the first motion
block, even if the plane axes are not involved, or if it requires a movement of the plane axes.
LCOMPTYP
Keep the longitudinal axis when changing planes
(G17/G18/G19).
Possible values: Yes / No.
Default value: No.
Associated variable: (V.)[ch].MPG.LCOMPTYPE
This parameter indicates which will be the longitudinal axis when changing planes
(G17/G18/G19). In either case, the longitudinal axis may be changed via part-program using