Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·871·
Variables related to the programmed functions.
Remarks.
This variable is initialized with a reset. If several channels are in the same group, the reset
of a channel means resetting all of them, thus initializing the variables of all the channels
of the group.
If there are several warnings, the value of the variable is updated as they are eliminated.
When the last warning is eliminated, this variable is initialized to zero.
REPOSITIONING OF AXES AND SPINDLES.
(V.)[ch]G.ENDREP
Variable that can be read and written via program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
All the axes are repositioned.
Syntax.
·ch· Channel number.
(V.)[ch].G.SPDLREP
Variable that can be read and written via program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
M function to be used to reposition the spindle after a tool inspection.
Syntax.
·ch· Channel number.
ACTIVE ZERO OFFSET.
(V.)[ch]G.EXTORG
Variable that can only be read from the program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
Function that defines the zero offset (zero offset or coordinate preset).
Syntax.
·ch· Channel number.
Values of the variable.
This variable returns one of the following values.
Remarks.
The numbering of zero offsets G54 through G59 is always the same; G54=1, G55=2, G56=3,
G57=4, G58=5, G59=6.
V.[2].G.ENDREP Channel ·2·.
V.[2].G.SPDLREP Channel ·2·.
V.[2].G.EXTORG Channel ·2·.
Value. Meaning.
0 G53. There is no zero offset.
1 - 99 G159. Zero offset (99 available).
If 1, G159=1; if 2, G159=2 and so on.
1000 G92. Coordinate preset.
To Next Page
Loading...
