Fagor CNC 8060 - Page 91

Installation manual
CNC 8060
CNC 8065
MACHINE PARAMETERS.
2.
(REF: 1402)
·91·
General machine parameters. Execution channels.
MOVEMENT OF THE INDEPENDENT AXES.
IMOVEMACH
Movement of the independent axis referred to machine
coordinates
Possible values: Yes / No.
Default value: No.
Associated variable: (V.)[ch].MPG.IMOVEMACH
This parameter indicates whether the movements of the independent axes are referred to
machine coordinates (IMOVEMACH = YES) or to part coordinates (IMOVEMACH = NO),
before the coordinate transformations.
XFITOIND
The transfer inhibit of the channel affects the independent axes.
Possible values: Yes / No.
Default value: Yes.
Associated variable: (V.)[ch].MPG.XFITOIND
This parameter indicates whether the transfer inhibit of the channel (_XFERINH mark)
affects the movements of the independent axis programmed from the PLC or not. The
transfer inhibit of the channel always affects the movements of the independent axis
programmed from the CNC.
DEFINITION OF THE SUBROUTINES.
SUBTABLE
OEM-subroutines table.
OEM subroutines are those associated with T, G74, G180 to G189, G380 to G399 functions
and interruption subroutines. These subroutines must always be in the following folder;
otherwise, an error message will be issued.
C:\CNC8070\MTB\SUB
When OEM subroutines have the .ram extension, the CNC will load them into RAM memory
on power-up.
TOOLSUB
Subroutine associated with "T".
Possible values: any text with up to 64 characters.
Associated variable: (V.)[ch].MPG.TOOLSUB
This subroutine is executed automatically every time a T function (tool selection) is executed.
REFPSUB (G74)
Subroutine associated with function G74.
Possible values: any text with up to 64 characters.
Associated variable: (V.)[ch].MPG.REFPSUB
Function G74 (home search) may be programmed in two ways. indicating the axes and the
order they will be homed or by programming G74 alone (without axes).
When executing a block that only contains the G74 function (without axes), it calls the
subroutine indicated in this parameter. This subroutine must contain the axes and the order
(sequence) to search home.
This subroutine is also called when homing the axis in JOG mode without selecting the axes.
XFITOIND Meaning.
Yes The _XFERINH mark affects the movement of the independent axis programmed
from the PLC and from the CNC.
No The _XFERINH mark does not affect the movements of the independent axis
programmed from the PLC; but it does affect the ones programmed from the
CNC.