19
SAFE OPERATION
2.12 Parking The Tractor
1. Lower all implements to the ground, place all
control levers in their neutral positions, set the
parking brake, disengage the PTO, stop the
engine, remove the key from the ignition Leaving.
transmission in gear with the engine stopped will
not prevent tractor from rolling.
2. Make sure that the tractor has come to a complete
stop before dismounting.
3. Avoid parking on steep slopes, if at all possible
park on a rm and level surface; if not, park across
a slope with chock the wheels. Failure to comply
with this warning may allow the tractor to move
and could cause injury or death.
2.13. Handling of ECU
1. Do not unplug or plug any sensor, ECU
connectors and do not cut off battery power
when ECU is in ON state.
2. Do not unplug battery terminal or cut-off battery
power when ECU is in ON State.
3. Do not unplug the ECU when ECU is in on state.
4. Don’t try to crank the engine when driver is not on
seat, any gear is engaged or clutch not pressed.
2.14. ECU ON-OFF State
For ECU On state
• Switch on the battery power Supply, then.
• Turn the Ignition ON.
For ECU Off State
• First Turn the Ignition Off, then.
• Wait for 1 minute.
Precautions Regarding the ECU
Never use ECU for the proposes that are not intended
by Farmtrac; such as using unauthorised ECU, writing
unauthorised data to ECU, leaving it broken, or
removing sensors and actuators. Doing so could
result in the violation of emission control regulation
and will void the product warranty.
Improper use or misuse of the ECU may result in
death or serious injury due to an abrupt and
unexpected increase in engine speed.
Be sure to use the ECU in conjunction with engine
whose model or serial numbers are specified by
Farmtrac. Other ECU/engine combination than
specified will void the engine warranty.
When replacing the fuel injector, you need to rewrite
the fuel injection quantity adjustment data in ECU. You
will need diagnostic tool for rewriting the data. Always
contact the authorised Farmtrac dealer that handles
the tool.
When replacing ECU, it is necessary to transfer the
data from the old ECU to the new ECU using service
based diagnostic tool. Contact your authorised
Farmtrac dealer who can handle the tool. If the data is
not correctly transferred to the new ECU, the engine
performance cannot be ensured.
1
1. ECU
Figure-14
To Next Page
Loading...
