Farmtrac 6050 E - Operating Procedure for Service Assisted Regeneration (Stationary; Manual Regeneration)

40
DPF REGENERATION
4.2.4.3 Operating Procedure for Service Assisted Regeneration (Stationary/ Manual Regeneration)
Ÿ Regeneration Operating Procedure
1. Start the engine.
(Make sure that the DPF inhibit switch lamp is OFF).
2. If by any chance earlier DPF lamp indication was missed or driver couldn't perform manual/ parked
regeneration, DPF lamp will start blinking fast.
3. Along with DPF lamp buzzer will start beeping with higher frequency and Service lamp will be turned
ON
4. Engine speed and torque will be de-rated.
5. Stop the work and remove the implement immediately.
6. Slowly take the tractor to Authorised Escorts Service Station
Ÿ In case above action is not performed and tractor is continuously run with above indicators, Service lamp
will start blinking and driver has to immediately take tractor to service station.
IMPORTANT: Once the regeneration level has been reached, immediately perform the required procedure
for regeneration.
Interrupting the regeneration cycle or continued operation by ignoring the warning signs may cause DPF and
engine damage.
Indicator Lamp Strategy
Regeneration DPF
Lamp
Service
Lamp
Buzzer DPF
Inhibit
Lamp
Indication
Action by
Driver
Driver Assisted
Regeneration
(PM1)
Slow
Blink
OFF
OFF
OFF
Normal Driving+
Stationary
Regeneration
Driver Assisted
Regeneration
(PM2)
Slow
Blink
ON
Slow
Beep
OFF
Stationary
Regeneration
Indicator Lamp Strategy
Regeneration DPF
Lamp
Service
Lamp
Buzzer DPF
Inhibit
Lamp
Indication Action by
Driver
Service Assisted
Regeneration
(PM1)
Fast
Blink
ON Fast
Beep
OFF Visit Service
Station
Service Assisted
Regeneration
(PM2)
Fast
Blink
Blink Fast
Beep
OFF Visit Service
Station