FARO
®
Laser Scanner Focus
3D
X 130 Manual
January 2014
81
Chapter 6: The Focus
3D
X 130 Controller Software
The scanner has a built in loudspeaker. Certain scanner events will be signaled by
various sound effects. You can change their volume here and switch sound
effects on or off.
Volume - Increase or decrease the volume of the scanner sounds.
Touch pad clicks - Switch sound to confirm button clicks on or off.
Sound during scanning - If switched on, the scanner will give a warning signal
when the laser is switched on and the scanner is scanning.
Sound when scan is finished - If switched on, the scanner will inform about
scan completion with a sound.
Sounds when warnings are issued - If switched on, the scanner will sound
when a warning is issued.
Sounds when warnings are issued - If switched on, the scanner will sound
when an error is issued.
Figure 6-18 Sounds
To Next Page
Loading...
