FARO
®
Laser Scanner Focus
3D
X 130 Manual
January 2014
58
Chapter 5: Getting Started
the inclinometer screen. For more information, see “Inclinometer (Dual Axis
Compensator)” on page 96.
Shutting Down the Focus
3D
X 130
To shut down the Focus
3D
X 130, shortly press its On/Off button or use the
shutdown button in the controller software under Home > Manage. All LEDs
will start blinking blue. As soon as the Focus
3D
X 130 has finished the shutdown
process the LEDs will stop blinking and you can safely remove the battery and
the power supply.
DO NOT turn off the power of the Focus
3D
X 130 before the shut down cycle is
complete. The Focus
3D
X 130 has a PC with a hard drive integrated. This internal
PC must be shut down before turning off the power supply. If the power supply is
disconnected or switched off without the Focus
3D
X 130 being previously shut
down, it may damage the internal PC and might lead to a loss of data. Pressing
and holding the button more than 10 seconds will switch the Focus
3D
X 130 off
without shutting down. Please use this option only if the Focus
3D
X 130 does not
shut down regularly because of a malfunction.
N
OTE: If the Focus
3D
X 130 had not been shut down properly, the next boot
process could take more time as usual as the Focus
3D
X 130 might check its
hard disk for errors. Some settings, which were made shortly before shutting
down the Focus
3D
X 130, might also be lost.
Powering Off the Focus
3D
X 130
Once the Focus
3D
X 130 has been completely shut down, disconnect the AC
power cable first, then disconnect the power supply cable from the Focus
3D
X
130, remove the battery and secure the equipment in protective cases.
Removing the Battery from the Focus
3D
X 130
1 Open the battery cover.
2 Push the fastener to release the battery.
3 Remove the battery.
4 Close the battery cover.
To Next Page
