FARO
®
Laser Scanner Focus
3D
X 130 Manual
January 2014
72
Chapter 6: The Focus
3D
X 130 Controller Software
No Parent Project - Select this button if the project is supposed to be a main
project with no parent project.
Customer - If you are carrying out the scan project by order of a company, you
can enter its name here.
File Base Name - The scan will be saved with a file name consisting of this base
name followed by the current scan number.
Initial Scan No. - Automatically increments with each successive scan. Can be
reset and may be used to indicate the number of scans per scan session.
Additional Info - Additional project information.
Latitude [°] - If known, enter the approximate (+/- 10° is sufficient) latitude
position of the scan project here. This information helps to improve the
calibration of the inclination sensor and leads to more precise inclination data and
thus to better scan registration results. Please enter the latitude value in decimal
degree notation.
Editing a Scan Project
To edit a scan project, select it in the list and touch it once again to reach to its
details view.
Selecting a Scan Project
The project list contains the currently selected project and all further projects
stored on the SD card.
Figure 6-11 Project List
To Next Page
Loading...
