FARO
®
Laser Scanner Focus
3D
X 130 Manual
January 2014
47
Chapter 5: Getting Started
Use GPS - Turn the GPS sensor ON or OFF. Unlike the other sensors, the GPS
data is only recorded during scanning and will thus only be available for scan
registration in SCENE if this button is switched to ON. For more information,
see “GPS” on page 100.
Click the Recommended Settings button to enable the use of all sensors.
P
LEASE NOTE: The available sensors vary depending on the scanner model.
Color Settings
(Home > Parameters > Color Settings)
Set the exposure metering mode - Set the way in which the integrated color
camera determines the exposure for taking the color photos (if colored scan
recording is switched on). Select beteween three exposure metering modes to
meet the requirements of the current lighting conditions and to get best possible
results for the area of interest.
Even Weighted Metering - To determine the exposure settings, the camera will
use the light information coming from the entire scene and averages without
Figure 5-21 Color
To Next Page
Loading...
