2-3
1
2
Installation and Connection
Installation
2-1-2 Attaching to/Removing from a DIN-rail
Installing the Amplifier
① Place the groove on the side of the fiber unit
holes on the DIN-rail.
② Press down until the hook locks.
Removing the Amplifier
① Push the amplifier toward the side of the fiber
unit holes.
② Lift up the side of the fiber unit holes and remove
it.
2-1-3 Mounting on a Wall
Attach the mounting bracket to the amplifier, using the same method as for mounting on a DIN rail, and then
fix the mounting bracket on the wall using two M4 screws, as shown on the drawings below.
2
1
2
Mounting bracket
To Next Page
Loading...